Due to the increasing market demand for the scale, intensification, energy conservation, environment protection and high-quality machine-made sand, LIMING, further optimizes the structure and function of traditional vertical-shaft impact crushers and launches a new generation of sand-making and reshaping machine with high efficiency and low costs — VSI6X Sand Making Machine.
Product Features: Lower maintenance costs, longer service life of vulnerable parts, bigger capacity
Input Size: 0-50mm
Capacity: 100-583TPH
Material: Granite, quartz, basalt, pebble, limestone, dolomite, etc.
Features Of VSI6X Sand Making Machine:
1. New design, efficient crushing
Impeller structure adopts the design of four openings to improve the material throughput. Compared to the three opening impeller, the crushing efficiency is improved by 20%.
2. Technology upgrade, cost decreasing and benefit increasing
“Crushing between material” work pattern is adopted to reduce wear-resisting type and cost; adjust some impeller structure and craft. Comparing with the earlier equipment, the impeller lifespan is raise up by 30-200% on the situation of same material.
3. Unique design, quality assurance
Equipment transmission parts special sealed cartridge bearing structure prevents leakage, won three national patents; good bearings, reduce transmission failure.
4. Efficient working, easy maintenance
New lifting device to facilitate customer maintenance of the equipment, saving labor; minimalist design effectively prevent blocking when the moisture content of the raw material is high, reduce downtime, and efficient operation.
Working Principle Of VSI6X Sand Making Machine:
The motor drives the main shaft to make the impeller to rotate at a high speed. The material which entered impeller will speed up and ejected to crushing chamber, and then impact with the material liner that shaped in crushing chamber. In this process, to make the kinetic energy got from speeding up transform to energy need for crushing and shaping. The material will recycle for many times in the crushing chamber. After many times crushing and shaping, by the function of around gas eddy, to achieve constantly crushing and shaping. The final products are discharged from bottom outlet of machine body. This crushing method is ‘crushing between materials’, and it is used for material shaping. Besides, this machine also has another crushing method ‘crushing between material and liner’. To compare with ‘crushing between materials’, the difference is: After material ejected from impeller, the material will impact with liner installed in crushing chamber. After impacting, the material will discharge from bottom outlet of machine body directly, and it does not recycle many times in crushing chamber. This crushing method is mainly used for crushing (target for large crushing ratio).
Specifications – Technical Data